Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a technical repair walkthrough, not a review or buyer's tour: it documents a known LS XJ2025 backhoe issue where a valve cap can overpressurize and blow out when the three-point hitch is raised with the backhoe hooked up. Dave shows LS's factory fix (adding a case drain, rerouting hydraulic lines, swapping fittings) hands-on, comparing an updated tractor to one being retrofitted. Most useful for current XJ2025 backhoe owners troubleshooting or performing this update themselves.
Appears to be an owner or operator working directly on the tractor, sharing a hands-on fix rather than a sales pitch.
It is caused by the way the hydraulic system is plumbed. Raising the three-point hitch lever while the backhoe is hooked up overpressurizes the valve, causing the cap to blow out.
LS added a case drain that eliminates the hitch from the hydraulic loop once the backhoe is hooked up, along with rerouted hydraulic lines and swapped fittings.
Pull the seat off, remove fourteen millimeter nuts, unplug the connector, then trace and reroute several hydraulic lines to match the correct ports shown on an updated tractor, swapping fittings as needed.
If under warranty, the dealer will likely handle it for you. Otherwise, with even small mechanical ability, the update is straightforward to do yourself.
