Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner-shot walkthrough of changing both the suction and HST filters on a Kubota B2650, with the standout detail being a vacuum trick, applied to the hydraulic fill cap, that prevents fluid from pouring out when the filter breaks loose. Covers part numbers, fluid spec, the often-missed difference in tightening torque between the two filters, and fluid level check afterward. Most useful to B2650 owners tackling this job themselves for the first time.
An owner-operator channel documenting hands-on maintenance from their own tractor, with no apparent commercial affiliation.
Pull a vacuum on the hydraulic fill cap while loosening the filter, leaving a slight air gap so it sucks air instead of letting fluid run out, saving about a quart.
The suction filter gets a half turn after contact with the housing, while the HST filter gets close to a full turn, around three-quarters before bottoming out.
An 80 millimeter filter wrench, which helps get the filters loose, along with UDD Super Transmission Hydraulic Fluid matching Kubota's recommendation.
Check the dipstick for the safe zone between the notch and ring, top off with fluid, then run the tractor in four wheel drive to circulate fluid before rechecking.
