Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a detailed operator-training walkthrough of a 4066R paired with a Norand inverted snowblower, not a sales or review video. It covers cab controls (ranges, hydrostatic pedals, 4WD, auto-throttle, rollout speed dial), PTO engagement habits, clearing plugged snowblower chutes with a shovel, shear-bolt locations, and grease-point maintenance. Aimed squarely at new owners who need to actually run this specific setup, not shoppers comparing tractors.
Posted by the Nick Bohner channel, who appears to operate multiple 4066R/snowblower setups and is teaching from hands-on operating experience.
Open the back hatch after removing safety pins, use the small shovel to scoop heavy wet snow from the top, push remainder down to the bottom area, then clear it out and close the hatch.
Engage or disengage the PTO at a lower RPM, anything between idle and about 2000 RPM is fine.
Four-wheel drive is fine when there is snow on the road, but make sure you are in two-wheel drive on dry pavement since running 4WD on dry pavement can cause damage.
Let it dry off, then grease the nipples for the main auger bearing, two points on the hood, and the PTO knuckles, plus one shot in the black box area.
