Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A first-person DIY walkthrough of installing a block heater on a Kioti DK50SE HST, filmed by the owner. Covers removing the side panel, knocking out the freeze plug, applying Loctite 609 equivalent, seating the sleeve, threading in the heater element with Teflon tape, and checking for leaks after a 24-hour cure. Also notes the Bobcat-compatible heater part and two freeze-plug removal methods. Best for DK50 owners in cold climates tackling this job themselves.
An owner-operator sharing a first-time DIY experience on their own low-hours tractor, with no commercial affiliation apparent.
The heater used is a Bobcat instrument, since the owner believes the same engines used in the DK50SE are also made for Bobcat equipment.
Knock it out with a sharpened punch and pull it with pliers, or drill it, insert a screw, and pry it out with a claw hammer.
The compound sets up in about an hour but the owner let it cure for 24 hours before continuing the install and checking for leaks.
No, after running the tractor about 20 minutes to normal operating temperature, there was no leaking whatsoever.
