Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Specifically covers removing just the blower unit while leaving the Bercomac subframe attached to the Mahindra 2638, a mid-season partial disconnect so the loader can be swapped back in. Walks through each step in real time: lowering the stand leg, relieving hydraulic pressure, unplugging the electric chute motor, disconnecting hoses and pins, and backing the tractor free of the splined PTO shaft. Most useful to owners of this exact snowblower setup.
Posted by the Crooked River Homestead channel, which appears to be an owner sharing practical how-to experience from their own tractor and property.
Unplug the chute motor wire, lower the stand leg, relieve hydraulic pressure, disconnect the chute rotation hoses, pull two pins, then back the tractor up to separate the splined PTO shaft, leaving the subframe mounted.
Because winter is not over, leaving the subframe on lets you remount the loader for yard work and quickly reattach the blower later without disconnecting the PTO shaft and hitch pin.
With the tractor off, move the control lever forward, back, and side to side in all directions to relieve pressure in the lines before disconnecting them.
