Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a detailed step-by-step DIY install of a Summit rear remote (triple spool) kit on a Kubota L3301, covering valve body assembly, fitting torque, mounting to the rock shield, hose routing around existing hydraulics, rocker switch box wiring, and battery hookup, ending with a leak check. It's install-focused rather than a review of performance or capability, best suited to owners planning their own installation.
Broll Brothers has a paid partnership with Summit and promotes a Summit discount code throughout, so expect an install tutorial rather than an independent product review.
Install it on the back right side of the rock shield as the manual recommends, using the included red adhesive rubber pads, then secure it with four hex nuts after removing grommets and cardboard.
Lubricate with hydraulic oil, snug the fitting to compress the O-ring, then apply about a quarter turn of additional torque. Valve hex nuts get snugged down to two foot-pounds.
Mount the bracket, screw in the rocker box, connect cables to the rear solenoid controls matching shortest pairs first, then run the power cable along hydraulic cables to the battery and attach ring terminals.
Close up the hood making sure cables are not pinched, then fire up the tractor and check all connections for leaks; the installer reported everything was leak-free.
