Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a straightforward how-to walkthrough, not a review or test drive: Ryan from Brim Tractor demonstrates the actual step-by-step process of detaching a backhoe attachment from a New Holland Workmaster 25S and swapping in a three-point hitch, including positioning, stabilizers, pins, hydraulics, and tire removal for hardware install. Best for current or prospective 25S owners specifically needing to switch implements, not general shoppers evaluating the tractor.
Posted by the BRIM TRACTOR channel, presented as a practical dealer/operator demonstration rather than an independent review.
Park on flat ground, lower the stabilizers, press the bucket against the ground to relieve pin pressure, remove the two frame pins, tilt the backhoe off, disconnect hydraulics, then drive away.
After removing the backhoe and driving away, remove the right rear tire so you can install the three-point hitch hardware.
Yes, after tilting the backhoe off the tractor frame, the next step is to disconnect the hydraulics.
