Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a real owner's repair diary for a Kubota LX2610 that kept blowing its OPC fuse and shutting off. The creator traces the problem through all three safety switches (neutral sensor, seat switch, PTO safety switch), identifies a broken PTO switch as the culprit, and walks through the teardown needed to reach it, seat removal, fender bolts, connector location, and the roughly $50 part cost. Good for owners troubleshooting the same shutdown/fuse issue.
Posted by the Andrew Washington channel, an LX2610 owner sharing a hands-on fix from his own troubleshooting experience.
A broken PTO safety switch shorts out from vibration, causing the tractor to cut off and blow the 5 amp OPC fuse and sometimes the OPC hazard fuse too.
Remove the seat, undo the seat bracket bolts, remove bolts inside the fender well on both sides, then unscrew the sensor and unplug it from its grommet.
The creator says the switch is about fifty dollars, and the seat switch alone, if it fails, is about six dollars.
Mostly 12 mm sockets, with an impact driver recommended, except for the large seat bolt which is 19 mm.
