Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a straight maintenance walkthrough covering every grease point on a 1025R: six per side on the loader, plus the underside points including power steering cylinder, both driveline U-joints, main drive shaft, and the three extra points if you have a belly mower quick-connect. It also gives the 50-hour interval and recommends John Deere SD polyurea or HD lithium grease. Good for owners doing their own routine service.
Posted by the 247Parts channel, which frames the content around parts and maintenance, so expect a practical how-to tone with occasional nudges toward buying supplies from them.
There are six grease points on each side of the loader, two at the front, two in the middle, and two near where it mounts to the tractor.
The operator manual recommends every 50 hours for the points underneath the machine, though the loader may need more frequent greasing if used heavily.
It is recommended to use John Deere SD polyurea or John Deere HD lithium complex grease, though any good quality grease will work.
There are three points: one at the U-joint connecting to the shaft underneath the machine, one in the middle of the shaft, and one at the U-joint connecting to the deck shaft.
