Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a straightforward, hands-on oil change on a JD 2210 with the Yanmar 3-cylinder diesel, bought at 750 hours from a government auction. It walks through locating the filter, draining old oil, replacing the filter, and refilling with 2.7 liters of 15W40/5W40, including how the owner measured the fill amount and checked the dipstick. Good for owners wanting a quick, basic DIY reference rather than deep diagnostics or torque specs.
Posted by an owner sharing a personal, DIY maintenance video on his own 2210 rather than a dealer or expert technician.
Open the hood and side panels, locate the filter on the right side, drain oil through the 14mm pan plug, replace the filter, then refill with 2.7 liters of 15W40 or 5W40 oil and check the dipstick.
About 2.7 liters, which is just over half a gallon.
The drain plug on the oil pan is 14 millimeter.
No, the video shows hand tightening the filter is enough, since the wrench used only works one direction and can't tighten it further.
