Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A pre-operation walkaround checklist specific to the LS MT232H, covering hydraulic/transmission fluid, engine oil, fuel filter and water separator, front axle gear oil, radiator and overflow tank, quick-clean radiator screen, air filter, battery connections, and grease points. The presenter includes practical tips, like lowering the loader before checking hydraulic fluid and letting the engine cool before reading oil. Best for new MT232H owners wanting a repeatable routine.
Posted by the TRACTORCITY channel, presented by someone named Ashton Pierce, whose perspective and affiliation are not established beyond that.
If the loader is raised, fluid stays in the rams, causing the hydraulic fluid reading to show lower than it actually is.
The presenter recommends doing it every 8 to 10 hours, or ideally every time before using the tractor.
Let the tractor run until hot, then let it sit about half an hour so oil drains down before checking the level with the yellow pull knob.
Turn the tractor off, pull the quick screen knob, clean the screen, put it back on, and go back to work.
