Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This clip catches the tail end of a DIY fuel filter swap on a John Deere 1023E, showing the new filter going back in, the clamps and vice grips used to pinch off the fuel lines, and a quick note about bleeding the water separator after startup. It's a narrow, hands-on snippet rather than a full step-by-step walkthrough, best suited for owners already mid-job wanting a sanity check on clamping technique.
Appears to be an owner-operator documenting their own maintenance work rather than a professional or dealer channel.
Small metal clamps and vice grips were used to pinch off the fuel lines, with a simple pair of regular pliers to slide the line back into place.
No, they worked better on the side with more scope and distance to work with compared to the short end, which was harder to access.
Fuel runs back into the water separator quickly after startup, so it needs to be bled.
