Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a step-by-step, hands-on fuel filter replacement on a 5055E, not a general overview. It covers tools needed, loosening bleed screws to relieve pressure, removing the plastic retaining clip, seating the new filter's alignment bumps correctly, and the full bleeding process using the top pump until fuel runs clear without air. Useful for owners doing their own 500-hour service who want the actual procedure, including tips on avoiding leaks and line damage.
Posted by the Beauty & the Beast Stables & Longhorn Family Ranch channel, appearing to be an owner performing their own maintenance rather than a dealer or professional mechanic.
You need the correct fuel filter, an adjustable wrench or 9/16 socket, a flat tip screwdriver for the bleed screw, and a 1/2 inch socket for another bleed screw.
John Deere lists the fuel filter change as a 500 hour service interval on the 5055E.
Loosen the bleeder screw, then pump the top pump by pushing down until fuel flows steadily without spurts of air, then tighten everything.
Feel for the groove and bump inside the filter housing, align the filter's bumps into the matching slots, then screw the plastic clip on hand tight.
