Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a step-by-step first oil change on an owner's own 2860E at 73 hours, showing both drain plugs, filter location and swap (including brand/origin details of the filter), and how to write service hours on the filter housing. It also digs into oil viscosity confusion between the Iseki manual (10W-30/5W-30) and an AGCO bulletin recommending 15W-40, settling on a 5W-40 synthetic. Useful for owners doing their own maintenance.
An owner-operator documenting hands-on DIY maintenance on his own tractor, including his personal product choices and reasoning.
The Iseki owner's manual recommends 10W-30 or 5W-30, but an AGCO bulletin says to run 15W-40 above 32 degrees F. The owner chose a 5W-40 full synthetic to cover both warm and cold conditions.
There are two drain plugs, one on each side of the double low oil pan, removed with a 19-mm socket. Drain both while the engine is a little warm so oil flows easily.
The oil filter is on the loader control side near the oil cooler. Remove the old filter, dab old oil on the new filter's seal, and install it reasonably snug by hand.
After installing the new filter, write the current engine hours on the filter housing with a marker, such as 73H, so you know when it was last changed.
