Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a narrow, task-specific how-to: removing and reinstalling the backhoe attachment on a Kubota BX25D. It walks through lowering stabilizers, pulling the main pins, disconnecting the three hydraulic hoses (capping fittings to avoid oil loss), driving away, then reversing the process to reattach. No pricing, digging, or general tractor review content here. Best suited for BX25D owners who need a step-by-step reference for swapping the backhoe on and off.
Appears to be an instructional/how-to channel focused on procedural tractor tasks rather than sales or reviews.
Lower the stabilizers, set the backhoe on the ground, pull the two main pins, then disconnect the three hydraulic hoses, capping the ends to avoid oil leaks, before driving away.
Three hoses: two 90-degree fittings at the top and one straight fitting, all of which get capped except the straight male coupler on the tractor side.
It must stay plugged into the tractor's coupler because it is a one-way hydraulic system, and oil will not flow properly if it is not connected.
Back the tractor up to the backhoe, reconnect the straight fitting then the two 90-degree fittings, start the tractor to pull the backhoe into the frame, insert the top pins, and raise the stabilizers.
