Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A first-timer's step-by-step walkthrough of swapping the fuel water separator filter on a Yanmar SA325 with 100 hours on it. The owner works through the job in real time using the manual, calls out the confusing part-number discrepancy, shares the online ordering cost (roughly $7-8 for the filter), and covers the reassembly details including O-ring and spring placement. Best for SA325 owners tackling this filter change for the first time.
An owner-operator documenting DIY maintenance on their own SA325, openly learning alongside the viewer rather than presenting as an expert.
The filter number used is 129053-55670, though the owner's manual lists a different, likely outdated, part number.
Ordered online from Yanmar, the filter cost roughly seven to eight dollars with free shipping.
The owner's manual says to clean it with diesel oil, so a small amount of fresh diesel fuel was swished around to remove sediment and dirt.
Put the O-ring back on the bowl, place the red plastic piece and spring inside, install the new filter, then reattach and tighten the collar.
