Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A step-by-step installation walkthrough for the factory rear remote kit on a TYM T25, filmed during an actual install. Tony breaks down every part in the kit, walks through removing the seat and existing hydraulic lines, mounting the new valve body, tightening compression and O-ring fittings in sequence, installing the lever and quick connects, and finishing with a live pressure test. Best for T25 owners planning to tackle this themselves.
An owner-operator channel focused on practical homestead tractor work, so expect hands-on guidance with honest tips rather than a sales pitch.
After watching the video you should be able to install the rear remotes in 30 minutes to an hour, since it is a really easy job.
Yes, the original O-rings may still be usable but often have flat spots, so replace them with the new ones included in the kit.
Crank the tractor, pull the lever to one side to pressurize it, then the other side, and check for leaks on both sides.
It is a rear remote valve with a detent that stays on instead of springing to center, used to power attachments like a backhoe.
