Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is an owner's exterior walkaround after two years of real hay-season use, not a dealer pitch. He covers the 931X loader and its leaky spool valves, front axle clearance, screen/radiator debris issues during haying, the AGCO three-cylinder engine's pull compared to a Perkins, tire choice, three-point hitch quirks, and suitability for baling 250+ acres a year. Part 1 stays outside; interior comes in part 2. Best for hay producers weighing this tractor for baling and cutting duty.
Posted by Bagwell Farms, an owner sharing hands-on impressions from actually running this tractor on their operation.
Yes, it works good for hay use and can run a 10 bale grapple on the front, handling rolls well.
The spool valves are smaller than standard, leak fluid at the bottom, and the owner plans to replace them after warranty.
The AGCO three cylinder has as much power as the Perkins but probably less low-end torque, and it holds RPMs well without pulling down.
It should handle a farm baling hay anywhere around 250 acres a year very well, best for baling, cutting, raking, and fluffing hay.
