Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A very short procedural clip walking through the steps to dismount a Mahindra backhoe, covering stabilizer positioning, releasing hydraulic pressure, pulling linchpins, disconnecting couplers, and capping two hydraulic hoses that must be looped together for the three-point to function. It's a quick reference rather than a deep tutorial, minimal explanation, no specs or torque values. Most useful to a Mahindra owner doing this for the first time and wanting a basic process check.
Posted by the KenoTractors channel, with no description or other context available to indicate their perspective or affiliation.
Lower the stabilizers and bucket to the ground, release hydraulic pressure, pull the linchpins, turn off the tractor, then disconnect the couplers.
The two hydraulic hoses must be looped back together to complete the circuit, or the three-point will not function.
Yes, disconnecting the couplers causes a small fluid leak, which is just whatever fluid was left inside the couplers.
