Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on DIY maintenance session on an 818-hour 2012 Kubota B2920, covering air filter replacement, engine oil and filter change, and a hydraulic fluid change with filters on both sides. It shows actual drain plug and dipstick locations, and includes real trial-and-error over hydraulic fill levels, including a follow-up correction after the owner realized he'd missed additional drain bolts. Useful for owners doing their own service on this model.
Posted by the Rankin Projects channel, an owner documenting DIY maintenance on his own tractor, including mistakes and corrections along the way.
Pull up on the brackets and undo two clips, remove the cover, then pull out the outer filter and the inner filter underneath it. Install new filters in reverse order and snap the cover back down.
The two drain bolts are located under the tractor near the front, just behind the front tires, along with the oil filter which can be loosened by hand.
The hydraulic fluid system takes four gallons, and there are filters on both sides of the tractor that should be changed along with the fluid.
The owner initially missed additional drain bolts on each side besides the main one, so old fluid remained trapped, causing the dipstick to read full even though less new fluid had been added than expected.
