Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Part 15 of an ongoing DIY clutch replacement series on a New Holland Boomer 40. This episode is a progress update rather than a how-to, the owner walks through what's done, what's waiting on parts (a brass throwout bearing bushing and a flywheel pickup), and the reassembly sequence planned for the next couple of days. Light on action, useful mainly for followers already invested in this specific repair series.
Posted by the trac nunya channel, which appears to be a private owner documenting their own hands-on repair work, with no channel description or credentials provided.
Loctite 242 thread locker on the throwout bearing bolt, Loctite 518 gasket maker on the Ford reverse transmission seal, and Permatex Ultra Gray for extra sealing not called for in the book.
The owner is waiting on a brass bushing for the throwout bearing, which will not arrive until two days later, holding up final reassembly.
The owner lines up the mark where the bolt goes, then adds Sharpie marks on the shaft ends to confirm correct orientation during installation.
