Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a narrow how-to focused entirely on hooking up and setting up a Ground Hog arena groomer, not a review or field demo. It walks through hitching to the three-point, leveling the blade front-to-back and side-to-side via top link and lift arms, adding the optional rear cylinder, bundling hydraulic hoses, and tightening sway bars. Useful for someone who already owns or is about to set up this implement and needs the adjustment steps.
Appears to be posted by the equipment maker or an affiliated installer, so it's an instructional setup guide rather than an independent review.
Lower the three-point until the back touches the ground, then adjust the top link so the back blade sits slightly lower than the front blade.
On level ground, lower the machine and check which side sits higher, then adjust the lift arm on that side of the tractor to raise or lower it.
Remove the ratchet jack arms by pulling the two pins, install the cylinder, adjust hydraulics if needed, and put the pins back in.
Tighten the sway bars so the machine is centered as much as possible while it is clear of the ground, using the latches on each side.
