Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Tony works through an actual red oak cleanup job, covering chipper-to-tractor matching, infeed speed adjustment by wood species, limbing technique to avoid jams, moisture effects on chipping, and, unusually, both the safe and his own shortcut method for clearing a clogged flywheel. It's a casual, learn-as-he-goes walkthrough rather than a polished tutorial, best suited to first-time owners figuring out the practical realities of running a PTO chipper.
An owner-operator sharing hands-on homestead experience, openly admitting gaps in his knowledge and inviting corrections from more experienced viewers in the comments.
Use the hydraulic infeed adjustment knob. White oak needs a slower feed since it is hard, red oak a bit faster, and soft woods like tulip poplar can run very fast.
A low horsepower tractor can only take wood so fast, so the hydraulic infeed wheel lets you slow intake down so the tractor can chew through it at a reasonable pace.
Turn the engine off completely, undo the bolt or latch, fold the access cover over on its hinge, and dig the clogged material out of the flywheel by hand.
Red oak, white oak, and hickories chip well because their Ys are true Ys. Elm and holly bushes chip poorly since elm limbs hook at 90-degree angles and jam.
