Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner walking through a full hydraulic and transmission fluid service on the Workmaster 75, this video goes deeper than most by uncovering an undocumented transmission filter, including its part number, approximate cost, and the fact that the manual never addresses its service interval. It also covers drain locations, correct fluid spec (M2C134D/Multi-G 134), filter O-ring inspection, and a cold-climate gelling question. Best for Workmaster 75 owners doing their own maintenance.
Posted by the CenTex Ag channel, presenting as a hands-on owner sharing personal experience servicing their own tractor.
The manual calls for M2C134D, which is equivalent to New Holland Ambra Multi-G 134 transmission oil, shared by the hydraulic reservoir and transmission.
The manual says it takes 9.2 gallons, though some fluid stays trapped in the lines and filter even after draining.
Yes, the owner found an undocumented transmission filter, part number 519-4879-0405-F, a paper element made in Italy costing about seventy dollars.
There are two drain points, one underneath the rear differential and one at the lowest point of the transmission, and both should be drained.
