Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on DIY repair walkthrough, not a review or buying guide: an owner rebuilds the tilt cylinder seals on a John Deere 4310 with a 430 loader, step by step, removing the snap ring, driving out the end cap, pulling old seals, installing new inner and outer seals with spoons, and reassembling with thread locker. Useful for owners tackling their own leaking loader cylinder rather than shoppers evaluating the tractor.
An owner-operator on the Southern Yankee Innovations LLC channel documenting his own DIY hydraulic cylinder repair.
Use snap ring pliers, or two flathead screwdrivers if you don't have pliers, after loosening the hydraulic lines and draining oil into a bucket.
Install the inner seals first because they are harder to install, which makes you less likely to damage the outer seals afterward.
Thread locker is used on the rod nut because if it comes off inside the cylinder, it creates a mess for the next repair.
After reinstalling the pins, reconnecting hydraulic lines, and re-greasing the pin, you function test it to make sure the leaks are gone.
