Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A first-timer walks through a basic DIY oil change on a John Deere 3032E, filmed on his own recently-bought tractor. It covers safety setup (loader down, brake set, in gear), draining oil via the single pan nut, swapping the filter, and refilling, noting the awkward fill spout and a stated 4.1 quart capacity. It's a quick, casual how-to rather than a deep technical breakdown, best suited for a new owner wanting reassurance the job is simple.
Posted by the Bama Hill-Billy channel, an owner sharing a hands-on, informal first attempt at this maintenance task on his own tractor.
Unscrew the single nut on the oil pan and let the oil drain out, then put the nut back on before refilling.
The video states 4.1 quarts, according to the person the tractor was bought from.
Lower the front end loader and any other attachment to the ground, set the emergency brake, and leave the tractor in gear so it cannot roll.
No, the video says it is a pain to refill and recommends using a bent or specific funnel to get oil in.
