Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a step-by-step DIY install video for a specific aftermarket part: a rear-mounted three-point lever kit for 20-series/Bad Boy 50-series cab tractors, sold by the channel itself. It walks through removing the tire for access, mounting the pivot bracket, attaching the handle with the nylon washer for tension, and installing the linkage bar, tool list included. Best for owners who've already bought or are considering this specific kit.
This is a seller/product channel demonstrating installation of its own kit, so expect a promotional lean alongside the practical instructions.
You need a couple of half-inch wrenches, ideally a ratcheting one, two half-inch sockets (one deep, one shallow), and a 3/4 inch socket with a 3/8 drive.
You can probably access it with the tire on, but removing the tire and wheel makes it much easier to reach the three-point lever inside the cab for mounting.
Place a nylon washer between the bracket and handle, then rotate the handle while tightening until it holds position without drifting but is not too hard to operate.
Yes, these kits are model and cab or non-cab specific, so you need to check which version fits your tractor before ordering.
