Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on DIY install of a rear remote valve kit on a 2022 MX6000 cab tractor, not a review or walkaround. It covers pulling the three-point arm, removing O-ring plugs, running hydraulic lines, torquing fittings, and the cab-specific hassle of removing the loader valve assembly, plus a critique of the factory instructions' gaps. Best suited to owners planning this exact install themselves.
Posted by the Skid-Co channel, an owner or technician doing their own wrench work and narrating as they go, not a dealer or scripted reviewer.
Yes. On cab models you must remove the loader valve assembly to access the area, something the factory instructions do not mention or explain.
Cut the lever tube itself to 3.3 inches, not the lever, so the handle pushes down fully and fits correctly.
It goes into the middle slot, not the far left slot as you might expect, and it sits well there.
No, the installer says the instructions are poor, missing steps like removing the loader valve assembly and showing unclear pictures of key parts.
