Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a narrow how-to, not a tractor review: an owner walks through detaching and reattaching the front-end loader on a Kubota L2502 with an LA526 loader, step by step, locking pins, kickstands, curling the bucket to relieve hydraulic pressure, dust caps, and realigning the loader bracket on reinstall. No pricing, specs, or performance discussion. Best for current or prospective L2502 owners specifically wanting the loader removal/installation procedure.
Posted by the Ryan Lynch channel, an owner demonstrating the procedure on his own tractor rather than a dealer or reviewer.
Set the parking brake, raise the loader, pull and lock the pins, lower until kickstands are one inch off the ground, roll the bucket out with light down pressure, then curl the bucket and hold to release fluid before the pins free up.
Align the round stock weld marks on both sides against the loader bracket, curl the bucket out then down, dump the bucket slightly, curl and drop in, then push the lever forward and reinsert the locking pins.
Curling the bucket, idling down, shutting off, and putting it in float with a little left and right movement helps get all the extra hydraulic fluid out before detaching the pins.
Yes, put the dust covers and dust caps on the hydraulic connections to make sure no water gets in while the loader is detached.
