Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a narrow, practical fix for one specific fault code: ECU 1209.13 on a 2018 John Deere 3032E, which put the tractor into limp mode. The owner shows exactly where the ECU sits, the two bolts and single clip holding it in, the 3/16 inch Allen wrench needed, and reports the dealership quoted $492 for the part but $1,268 installed. Useful mainly for owners troubleshooting this exact code.
Posted by an owner sharing a DIY repair from personal experience, with an openly cost-saving, anti-dealership angle.
It put the tractor into limp mode; the video does not explain the code's meaning, only how to fix the fault by replacing the ECU.
The John Deere dealership quoted $492 for the part alone but $1,268 to install it, including about $800 in labor.
Remove two bolts with a 3/16 inch Allen wrench, unplug one clip, slide the old ECU out, then install the new one and reconnect the clip.
A 3/16 inch Allen wrench is all that is needed to remove the two bolts holding the ECU in place.
