Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a full hands-on walkthrough of a BX2360 front axle oil change on the owner's own overdue tractor, not a quick overview. It shows locating both drain and breather plugs (14mm), draining and inspecting the old oil, the 5-quart capacity, refilling with UDT2 (or SAE 80-90 gear oil alternative) to the dipstick line, and the 10-minute settling step before final topoff. Best for owners doing this service themselves for the first time.
An owner-operator performing maintenance on their own Kubota as part of an ongoing series of Kubota maintenance videos on their channel.
Both the drain plug and the breather plug on each side are 14mm, and each drain plug has a washer that should be cleaned and reused.
The front axle has a 5-quart capacity. The video shows putting in four quarts first, then letting it settle and topping off to the dipstick line.
Kubota recommends UDT2, the same fluid used in the hydrostatic transmission. Some owners use SAE 80-90 gear oil instead, which is thicker and fine under heavier load.
Yes, the manual says to let it set for 10 minutes after refilling before reinstalling the drain and breather plugs, then check the level and top off as needed.
